Decorative putty, for interior work.

Šios konfiguracijos produktų neturime
About product

Area of ​​application: OSB boards, plaster, concrete, plasterboard, etc. for decorating mineral surfaces inside buildings.

Properties: ready-to-use, tintable, good adhesion to the surface, weak, specific smell, plastic, easy to apply and shape, allows to obtain very different textures of the surface to be decorated, does not "sit" very little and does not crack when drying, weakly absorbs water.

Surface preparation: Surfaces must be clean, sound and dry. To remove adhesion-reducing substances - grease, grease, dust, glue, mortar residues, old peeling paint, chalky surfaces. Weak and porous surfaces must first be primed with PRO UNIGRUNT primer, then with PRO.KONTAKT adhesion-enhancing primer, solid surfaces (concrete, GKP surfaces) should be immediately primed with PRO.KONTAKT adhesion-increasing primer (if the decorative plaster is tinted, the primer is also recommended to be tinted with the color corresponding to the decorative plaster).

Decoration conditions: the temperature of the base and environment during work and drying must not be lower than +5°C, the optimal conditions for puttying are at a temperature of +20°C and 65% relative air humidity. Do not work in direct sunlight or strong drafts. After reinforcing or plastering with mineral plaster, apply decorative putty PRO.DEKOR no earlier than 14 days later.

Decoration: Before use, mix the putty lightly until smooth. For the area to be decorated, it is recommended to use a decorative putty of one batch and one pigmentation. Apply the decorative putty on the surface with a metal spatula in a layer of 1-8 mm. Depending on the desired texture of the surface to be decorated, shape the applied putty with spatulas (can also be toothed), specially designed paper, various brushes, decorating rollers, and other decorating tools. If the temperature during work is higher than +25°C, moisten the surface to be formed with water using a sprayer. After forming the texture of the surface to be decorated, the putty is allowed to dry. The dried surface must be scrubbed with a scrubbing mesh, dusted and covered with a matte or glossy primer - varnish PRO.DEKOR, which can be tinted by adding the construction pigment PRO COLORANT of the desired color or coloring pastes for coloring paints.

Consumption: 2 - 16 kg/m² (depending on the structure of the surface to be decorated).

Drying time: at an air temperature of +20°C and a relative air humidity of 65%: fully dries in 8-72 hours (depending on the applied putty layer).

Cleaning tools: Rinse tools with water immediately after work.

Storage and transport conditions: at a temperature not lower than +5°C and not higher than +30°C in a tightly closed container. Protect from freezing!

Technical data: binder - copolymer acrylic dispersion; density (comparative weight) – 2kg/l; diluent - water.

Environmental and occupational safety: Do not pour putty into drains, watercourses or soil. Use skin and eye protection. In case of contact with eyes, rinse immediately with plenty of water and consult a doctor. KEEP AWAY FROM CHILDREN! EUH208 - May cause an allergic reaction. Contains 3(2H)-isothiazolone, 5-chloro-2-methyl- mixture with 2-methyl-3(2H)-isothiazolone, 1,2-benzisothiazol-3(2H)-one and 2-methyl-2H-isothiazolone - 3-on